![]() The owner of my company does not realized how big of our network infrastructure we have along with all of our property locations, and then all the end users.The past IT Manager did not do any upgrades since 2009, when it came to the backend network equipm.Ĭan we talk about passwords? I know, I know. CEO does not think I do anything IT & Tech Careers.If you enjoy the following incoherent ramblings of Spark! Pro Series - 14th November 2022 Spiceworks OriginalsĪnother Monday is upon us.And furthermore, what platforms should a business owner create content on to properly engage with. Nerd Journey # 194 - Question Askers and Problem Solvers with Neil Thompson Best Practices & General ITīusiness owners may be very good at knowing their target market, but they must also decide what roles / tasks will be outsourced vs.We can make a cable that converts a USB-C connection into a full blown docking station with multiple HDMI monitors and a USB hub and Ethernet, why can't we make one that does the much simpler task of forwarding those signals?Īnd, all that aside, my original question still stands: where can I buy an 18" / 0.5m extension cable so I can use the aforementioned port replicator on my desk? I can see why it would be expensive to make one that works, but not why it would be difficult. I still don't see why it is difficult to manufacture a cable. Thanks for helping out, Kirk, this is useful information that I did not have previously and it makes sense now why there is complexity to making a cable. Kind of like a mile-long Cat5 patch cable. Even if all the wires are straight-through, the extra length is likely degrading the signals enough that it just won't work, at least not reliably. ![]() So, as I understand it, there's really no such thing as a passive extension cable. ![]() Plus, the signal spec for the latest version has a maximum cable length of a meter or less. It uses all the pins, all the time, with the logic in the cable (and/or the connector) figuring out which way the cable is inserted and adjusting the signals appropriately. In other words, just because the cable can be flipped doesn't mean it has just one set of signal pins that are duplicated on the other side. Apparently, the connector is symmetrical, but the pins are not identical. Not being an electrical engineer I am unable to grasp A) why a USB-C connector cannot be wired to function regardless of orientation, and B) why this is a difficult thing to build. Thank you for checking for me, I appreciate you taking the time. i guess i didn't notice since i must have done it correctly on the first attempt. The electrons won't know or care whether the connection is physically soldered onto a circuit board or if it is a pressure contact inside a plug housing.Ĭan anyone point me at a USB-C extension that simple extends the wires (and thus each and every electron and signal on said wires) without being dumb? There is no need for anything stupid in between, no electronics, no processing, no ID chip, it just needs to transfer electrons along 18-36 inches of copper.Įvery device (not just USB, EVERY device) has a cable soldered on to its board, said cable being a series of copper wires, and at the other end is a plug. you get the picture.An extension cable should have a male plug on one end, a female plug on the other, and have wires between them to carry voltage. Myįirst round at searching has brought up only extension cables that don'tĬarry all the signals, or that need to be plugged in 'right side up', Its stupidly short cable, and bring that extension to my laptop. Want to call it) at the back of the desk, connect a USB-C extension to I want to place my docking station (or port replicator, or 'USB-C hub,' or whatever you I've done a little searching for what **should** be a very simple I apologize up front for being a bit grumpy, but I hope you can understand my frustration and see past it to help me out.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |